Luke's Customs
Emag 
 
Home  Products  Contact  Checkout 
 
Emag Frame ULE Milling
$40
This does NOT include removing the front part of the trigger guard.
Customer is responsible for stripping the frame.
*************************************************************************************

Emag Selector Switch

Order # EMS-2 

$12

Available in Black, Raw or Red (while supplies last, red will be discontinued)

       

*************************************************************************************

Aluminun Emag Panels

Sold as "BLEMS".

RAW $10

Dust Black $18

Purchase a set of "blems" and get an Emag switch for $6.

These are being sold as "blems" because of a screw-up during production.

The Emag switch "cut out" was cut a little too deep. See picture for details.

I can't absorb the cost of finishing on these, so powder coated sets will be an additional $8.

 

*************************************************************************************
 Emag Battery Pack Milling
$25
***********************************************************
Mill rear hump off Emag frame
$15
Customer must strip frame before sending in for machining.
************************************************
Emag Battery Pack adapter
$15
This allows you to mount an Emag battery to any rail.
It mounts to the rail like a ASA or fore grip.
 ********************************************************
Emag Battery Pack ASA Manifold
$37.50

This is a replacement part for your AGD factory top.
It allows you to mount a regulator inside a factory pack for a sleeper pneumag.

Comes with two 10-32 mounting screws and one 10-32 plug.

This requires a slot in your rail to mount the pack.

You should be able to use it on any rail of your choice including an AM/MM rail. 

 

The picture belows shows the inside of the pack from the bottom view.

Regulator and Microline fitting shown in picture.

********************************************************