AGD Warpfeed
45* Elbows $9 ea
45* elbows help the warp hose clear the bottom of your hopper.
They also fit AGD ULE and SS feed tubes.
90* Elbows $9 ea
12V Warpfeed Mod $15
Speed up that Warp with a drop in kit.
This kit converts a stock 9v system to an 12 volt system.
No mods necessary, simply attach to 9v battery lead and your ready to roll.
This mod is okayed by AGD.
Warpfeed On/Off with Red LED mod. $25 installed
You must send in your Warpfeed for this mod, it is not a drop in kit.
There is no hacking here. The areas where the on/off and LED mount are milled out for a clean install.
Intel Switch with screws $15
Warpfeed Forward $25 Available in Dust Black or Raw
Can be mounted left or right handed.
Mounts your warp and hopper very close and parallel to your marker.
It will be necessary to modify your hopper. View hopper mod HERE.
Mounts to the inside of your Warp case via the front to screw holes.
(Mounting screws included.)
These are no longer sold with the "slot" in the bracket (Pictured below).
(The current design is pictured above) The configuration is still the same.
Warpfeed-Rear $25 Available in Dust Black or Raw
NO mods are necessary to use this bracket.
Can be mounted left or right handed.
Mounts to the inside of your Warp case via the front to screw holes.
Fits 68 & 88 cube (and smaller) air systems.
It places your Warp and hopper parallel to the marker and beside the tank.
If you hate reaching around the Warp while holding the Foregrip, this is your set up!
It places the Warp in the crook of your arm while the marker is shouldered.
(Mounting screws included.)
